MG TD15470 Restoration » Tub and Wings » Floors

email Dave Braun at dave@dbraun99.com (click here)

The wooden floors, the prop shaft tunnel and the gearbox tunnel. Also, the side curtain box and the rear flooring.

Gas pedal out before Gearbox tunnel-1	Hand brake out before Gearbox tunnel	drive shaft tunnel rear bolts five of them	Main floor out-1	LH RH flooring 2
front floorboards painted	rear tub wood and framing	rear flooring 1	rear floorboards painted	Gearbox cover with adhesive
Gearbox cover clean	Gearbox cover done	cleaning prop shaft tunnel	prop shaft tunnel inside	prop shaft tunnel outside needs blasting
inner floor rails cleaned	Rubber blankets for inner floor rails front	Rubber blankets for inner floor rails	inner floor rails installed 2	Master Cylinder Access
Master cylinder access installed	Seabrook wood has UNC hardware	T nuts salvaged from old floor	removing UNC hardware	BSF hardware
Typical installation of hardware	side curtain box prep1	side curtain box prep2	side curtain box prep3	Wire brushing sides of side curtain box
Needs more wire brushing 2	Ready for prime 2	Primed side curtain box	Primed side curtain box 2	Primed side curtain box inside
Black satin finish side curtain box	Black satin finish side curtain box 2	Bottom of side curtain box is thin and pitted	Cloth hole plugs	Epoxy Resin
Resin poured in bottom	Resin reinforced bottom	Test fit rear floor and side curtain box	Silicon bead along floor rails	Prop shaft tunnel installed
Side curtain rear fastners	Filling poorly measured rear floor holes	Repaired misdrilled holes 01	Repainted rear floor	Rear floor installed
Rear floor access panel detail	Test fitting floors 04	Test fitting floors and gear box tunnel	Screwing down floor	Installing gear box tunnel
Bead of RTV sealant	Fitting sound deadner to gearbox cover 02	Fitting sound deadner to gearbox cover 03	Fitting sound deadner to gearbox cover 01	Sound deadner on prop shaft cover
Passenger foot rest fastners 01	Passanger foot rest installed

62 Images | © JAlbum & Chameleon | Help