Up MG TD15470 Restoration » Progress and Milestones Prev Next Slideshow

Previous image Next image Index page
Front suspension installed
Cover off
Finally empty gearbox
Safety wire for selector shaft
clutch rod after improvement
  Head on work table.JPG - Head on work table. Tearing down the engine for examination and rebuilding. The bearings were shot, and number one cylinder had a burnt valve and the top ring on number one was snapped in three places.  
checking fit of rear seal and crank mains
timing chain installed to set valves
Wood stove stoked up for painting
first coat of paint
mating gearbox to engine 2

Head on work table. Tearing down the engine for examination and rebuilding. The bearings were shot, and number one cylinder had a burnt valve and the top ring on number one was snapped in three places.
« | < | 21 | 22 | 23 | 24 | 25 | 26 | 27 | 28 | 29 | 30 | 31 | 32 | 33 | 34 | 35 | 36 | 37 | 38 | 39 | 40 | > | »
Total images: 94 | Help