Up MGTD15470 » Instruments & Fascia Panel » Fascia and Panel restoration. Prev Next Slideshow

Previous image Next image Index page
Mirror in place and trim for glove box
Test fitting panel with clamps
Straightening speedometer cured relief problem
Test fitting fascia with piping
Working out location of Turn Signal SW
  Installing dash piping.jpg - Moving the piping in to better fill the gaps at the two corners. Notice the tie bracket screws for the metal ties? I think they are too low, and are not pushing the lower part of the fascia panel forward. This is also screwing up the angle of the windshield screws.  
Adding shim to bring panel out
Removing excess material at glove box
Tinning new starter cable
Getting ready to wire in instrument panel
Glove box installed

70 | Moving the piping in to better fill the gaps at the two corners. Notice the tie bracket screws for the metal ties? I think they are too low, and are not pushing the lower part of the fascia panel forward. This is also screwing up the angle of the windshield screws. Download
« | < | 61 | 62 | 63 | 64 | 65 | 66 | 67 | 68 | 69 | 70 | 71 | 72 | 73 | 74 | 75 | 76 | 77 | 78 | 79 | 80 |
Total images: 80 | Help