MG TD15470 Restoration » Instruments & Fascia Panel » Fascia and Panel restoration.

email Dave Braun at dave@dbraun99.com (click here)

The original panel was red, to match the interior. When the black interior went in, the panel was changed to black. Now, it will be green, and the wiring replaced.

Instrument panel rear 6	Instrument panel out	glove box and welting	Fascia before tear down 2	facsia prior to tear down 1
Tach and speedo from behind	Instrument panel from behind	glove box door from behind	glove box door mount	instrument panel hole
carriage style fastners for instrument panel	Horn and dipswitch disassembled 2	Horn face before	horn pinch terminal	horn shoe polish
resister socket installation ignition and fuel	ammeter installation	glove box door hinges	Fascia panel holes and vinyl	glove box opening trim
glove box door dovetail joint	glove box door socket hole	glove box door vinyl	glove box door vinyl front	fascia panel before vinyl removal 2
fascia panel bagged parts	tracing of fascia for kevin 1	tracing for kevin tach and speedo	tracing for kevin glove box	fascia painted
cutting out pieces of vinyl	experimenting with 3M general adhesive and clamps	finished door except it is too big	glued on vinyl on fascia	ready to dart insturment openings
staples on fascia	trimmed out fascia panel parts	masked instrument panel chrome edge and sandblasted	blasted and masked for painting	painted and clear coat
instrument panel ready to install	repaint instrument panel with moss color	wearing in stiff tach reduction box	removed end of tach cable housing	label on spare speedo cable housing
end of spare speedo cable housing	spreading swaged end of speedo cable housing	brazed on end of tach cable housing	tach cable installed	checking fit of instrument panel
painting carriage bolt heads	fascia panel nearly complete	wiring instrument panel and dash	gauge lighting	choke crescent from kevin gunther
choke crescent creating0001	choke crescent creating0002	Original style ignition and headlamp switch	Origninal switch broken tab	Glove box ball catch
brackets on either side of glove box	Proper location for tach cable bracket	Odometer adjustment relief is short	Relief for the odometer knob	Mirror in place and trim for glove box
Test fitting panel with clamps	Straightening speedometer cured relief problem	Test fitting fascia with piping	Working out location of Turn Signal SW	Installing dash piping
Adding shim to bring panel out	Removing excess material at glove box	Tinning new starter cable	Getting ready to wire in instrument panel	Glove box installed
How deeply the sub fascia is fitting	Seven shim washers	Position of dash after shimming the sub dash 2	Position of fascia after shimming the sub dash	Fascia installed

80 Images | Made with JAlbum & Chameleon | Help